Does anyone have any experience with the revmaster 2100d vw conversion. Can it be made to fit a Nipper? I have a new Leburg ignition (The engine is currently fitted with Lucas coils).
Many thanks Richard
Nipper No 36
07787518662
Revmaster engine
-
Neil Spooner
- Posts: 631
- Location: Ardleigh, Colchester, Essex, UK
- Contact:
Re: Revmaster engine
Hi Richard,
The revmaster engine crankcase is a VW case clearanced internally to allow use of a longer stroke crankshaft. I would think that the engine would not be a problem to fit, although you will have to discard the accessory case on the back (if you have it). One area that could cause some issues is the longer crankshaft. I believe the flange is about 3inches further forward of the std VW, but I am not sure of the exact measurement.
Good luck with the project.
Neil
The revmaster engine crankcase is a VW case clearanced internally to allow use of a longer stroke crankshaft. I would think that the engine would not be a problem to fit, although you will have to discard the accessory case on the back (if you have it). One area that could cause some issues is the longer crankshaft. I believe the flange is about 3inches further forward of the std VW, but I am not sure of the exact measurement.
Good luck with the project.
Neil
A little help goes a long way.
Nipper G-BRPM and G-BALS
RV4 G-IKON
Nipper G-BRPM and G-BALS
RV4 G-IKON
Return to “ENGINEERING AND MAINTENANCE”
Who is online
Users browsing this forum: No registered users and 2 guests
